Door Switch (Front / Rear Door) Inspection; Rear End Door Switch Inspection; Outside Air Temperature Sensor Removal And Installation (If Equipped); Outside Air Temperature Sensor Inspection (If Equipped) - Suzuki Swift Sport 2004 Service & Repair Manual

9C-17 Instrumentation / Driver Info. / Horn:

Door Switch (Front / Rear Door) Inspection

Remove door switch from body and check switch for
continuity. If found defective, replace switch.
Door switch (front / rear door) specification
OFF position (Door closed): No continuity
ON position (Door open): Continuity

Rear End Door Switch Inspection

Check for continuity between terminal "a" and "b" shown
in the following.
If check result is not as specified, replace switch.
Rear end door switch specification
Rear end door closed: No continuity
Rear end door opened: Continuity
S7RS0B9306011
I3RH0A930004-01
S7RS0B9306012
a
b
I4RS0A930015-01
Outside Air Temperature Sensor Removal and
Installation (If Equipped)
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
3) Disconnect connector from outside air temperature
sensor.
4) Remove outside air temperature sensor (1) from
front bumper member.
1
Installation
Reverse removal procedure for installation.
Outside Air Temperature Sensor Inspection (If
Equipped)
Measure resistance of outside air temperature sensor
using an ohmmeter.
If resistance is out of specification, replace outside air
temperature sensor.
Outside air temperature sensor resistance
1.61 kΩ – 1.79 kΩ at 25 °C (77 °F)
5.50
"A"
1.70
0
32
"A": Resistance
S7RS0B9306013
I4RS0A930016-01
S7RS0B9306014
25
77 F
"B"
I4RS0A930017-01
"B": Temperature