Set Port Flowcontrol - Avaya P330 Reference Manual

port
Example:
P330-N# set port enable 4/1
Port 4/1 enabled.

set port flowcontrol

User level: privileged, supervisor.
Use the set port flowcontrol command to set the send/receive mode for
flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each
direction (send or receive) can be configured separately.
The syntax for this command is:
set port flowcontrol {receive | send | all} <module/port> {off
| on | proprietary}
receive
send
all
module
port
off
on
Avaya P330 Reference Guide
Chapter 2
Number of the port on the switch.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on switch 4.
Indicates whether the port can receive administrative status
from a remote device.
Available only for Gigabit Ethernet modules with negotiation set to off.
Indicate whether the local port can send administrative status to
a remote device.
Available only for Gigabit Ethernet modules with negotiation set to off.
Send and receive (symmetric flow control).
Number of the module.
Number of the port on the module.
Used with receive to turn off an attached device's ability to send
flow-control packets to a local port. Used with send to turn off
the local port's ability to send administrative status to a remote
device.
Used with receive to require that a local port receive
administrative status from a remote device. Used with send, the
local port sends administrative status to a remote device.
Avaya P330 Layer 2 CLI Commands
67