Show Port Auto-Negotiation-Flowcontrol-Advertisement; Show Port Blocking - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

show port auto-negotiation-flowcontrol-advertisement

User level: privileged, supervisor.
Use the show port auto-negotiation-flowcontrol-advertisement
command to display the flowcontrol advertisement for a Gigabit port used to
perform auto-negotiation.
The syntax for this command is:
set auto-negotiation-flowcontrol-advertisement [mod_num/
port_num]
mod_num
(optional)
port_num
(optional)
Example:
P330-N>show port auto-negotiation-flowcontrol-
advertisement
Port 1/1
Port 1/2
Port 1/3

show port blocking

User level: user, privileged, supervisor
This command is not available on P330-ML switches.
If this command is to be implemented on a switch other than the stack master, a
session should be opened to the relevant switch.
Use the show port blocking command to display the port blocking mode on a
particular switch. Use the session command to change switches before using this
command.
If this command is to be implemented on a switch other than the stack master, a
session should be opened to the relevant switch.
The show port blocking command is used with the
show self-loop discovery command to confirm a port's blocking mode.
The syntax for this command is:
show port blocking
126
Number of the switch
Number of the port
advertises no flow control capabilities.
advertises no flow control capabilities.
advertises no flow control capabilities.
Avaya P330 Reference Guide