Show Snmp Retries; Show Snmp Timeout; Show Spantree - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

show snmp retries

User level: user, privileged, supervisor
Use the show snmp retries command to display the number of retries initiated
by the P330 Manager when it tries to send SNMP messages to the device.
The syntax for this command is:
show snmp retries
Example:
P330-N>show snmp retries
the SNMP Retries Number is 3

show snmp timeout

User level: user, privileged, supervisor
Use the show snmp timeout command to display the default SNMP timeout in
seconds.
Tip: This command is useful for access using the Device Manager.
The syntax for this command is:
show snmp timeout
Example:
P330-N>show snmp timeout
the SNMP Timeout is 2000

show spantree

User level: user, privileged, supervisor
Use then show spantree command to display spanning-tree information.
The syntax for this command is:
show spantree [<mod_num>[/<port_num>]]
mod_num
(Optional)
150
Number of the switch. If you do not specify a number, all
switches are shown.
Avaya P330 Reference Guide