Set Port Enable; Set Port Flowcontrol - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
full
half
Example:
To set port 1 on module 4 to full duplex:
P460-1# set port duplex 4/1 full
Port 4/1 set to full-duplex.

set port enable

User level: read-write, admin.
Use the set port enable command to enable a port or a range of ports.
The syntax for this command is:
set port enable [module/port]
module
port
Example:
P460-1# set port enable 4/1
Port 4/1 enabled.

set port flowcontrol

User level: read-write, admin.
Use the set port flowcontrol command to set the send/receive mode for
flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each
direction (send or receive) can be configured separately.
The syntax for this command is:
set port flowcontrol {receive | send | all} <module/port> {off
88
Set full-duplex transmission
Set half-duplex transmission
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
Avaya P460 Reference Guide