Show Cascading Fault-Monitoring - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands
Example: (by MAC address)
P330-N# show cam mac 00-00-81-01-23-45
Dest MAC/Route
--------------
00-00-81-01-23-45
00-00-81-01-23-46
Total Matching CAM Entries = 2
Example: (by Module/Port)
P330-N>show cam 1/1
show cam 1/1
Dest MAC/Route Dest Destination Ports
------------------- -----------------
00-40-0d-59-03-78
00-d0-79-0a-0a-da
00-40-0d-43-1e-e9
...
00-40-0d-c6-24-01
Total Matching CAM Entries Displayed = 178

show cascading fault-monitoring

User level: user, privileged, supervisor
Use the show cascading fault-monitoring command to display the status of
the fault trap sending mode for cascading links.
The syntax for this command is:
show cascading fault-monitoring [<mod_num>]
Example:
P330-N>show cascading fault-monitoring 1
Module 1 cascading-down fault monitoring enabled.
Module 1 cascading-up fault monitoring enabled.
104
Destination Ports
-----------------
2/9
2/9
1/1
1/1
1/1
1/1
Avaya P330 Reference Guide