General Virtual Service Commands; Show Persistency-Table - Avaya P330 Reference Manual

Chapter 4 Load Balancing CLI Commands

General Virtual Service Commands

This section describes the Virtual Service commands used in all of the following
Virtual Service sections.

show persistency-table

User level: user, privileged, supervisor
When the persistency is enabled in the virtual service, use the
show persistency-table command to display the resulting persistency table.
The syntax for this command is:
show persistency-table <virtual-service> <type ><rsg> [<src-
ip> <src-wildcard> [<dst-ip> <dst-wildcard>]]
virtual-service
type
rsg
src-ip
src-wildcard
dst-ip
dst-wildcard
304
The name of the virtual service, a string of up to 32
characters.
The application type. Can be:
routing-fw | bridging-fw | ar | slb
The name of the real server group, a string of up to 16
characters.
The IP address of the source.
The source IP address's network wildcard.
The destination IP address.
The destination IP address's network wildcard.
Avaya P330 Reference Guide