Show Queuing Scheme; Show Radius Authentication; Show Rmon Alarm - Avaya P330 Reference Manual

show queuing scheme

User level: user, privileged, supervisor
This command is available on P330-ML switches only
Use the show queuing scheme command to display the current queuing scheme
settings.
If this command is to be implemented on a P330-ML switch other than the stack
master, a session should be opened to the relevant switch.
The syntax for this command is:
show queuing scheme
Example:
P330-N>show queuing scheme
Queuing scheme: default

show radius authentication

User level: user, privileged, supervisor
Use the show radius authentication command to display all RADIUS
authentication configurations.
The syntax for this command is:
show radius authentication
Example:
P330-N>show radius authentication
RADIUS authentication parameters:
---------------------------------
Mode:
Primary-server:
Secondary-server:
Retry-number:
Retry-time:
UDP-port:
Shared-secret:

show rmon alarm

User level: user, privileged, supervisor
Use the show rmon alarm command to display the parameters set for a specific
alarm entry that was set using the rmon alarm command on or using the P330
Avaya P330 Reference Guide
Chapter 2 Avaya P330 Layer 2 CLI Commands
Enabled
192.168.42.252
192.168.48.134
4
5
1645
sodot
143