Chapter 3
Avaya P330 Layer 3 CLI Commands
ip routing
User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip routing command to enable IP routing.
Use the no ip routing command to disable the IP routing process in the device.
By default, IP routing is enabled.
The syntax for this command is:
[no] ip routing
Example:
Router-N(configure)# ip routing
Router-N(configure)#
ip simulate
User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the ip simulate command to check the policy for a simulated packet. The
command contains the addressed list number, and the packet parameters.
The syntax for this command is:
ip simulate <access-list-number> [<priority>] [<dscp-
value>]<source> <destination> [<protocol> [<source port>
<destination port> [<established>]]]
access-list-number
priority
dspc value
source
destination
protocol
186
nteger (100 - 149, 0 is the default list)
fwd0 | fwd1 | - | fwd7
dscp0 | dscp1 | - | dscp63
source ip address
destination ip address
ip | tcp | udp | integer (1 - 255)
Avaya P330 Reference Guide