Chapter 4
Load Balancing CLI Commands
VLAN Area Commands
This section describes the vlan-area commands.
set vlan-area
User level: privileged, supervisor
You can also configure this command in user mode.
Use the set vlan-area command to create a mapping between the VLAN and
the area.
The syntax for this command is:
set vlan-area <VlanID> <clients | servers>
VlanID
clients
servers
Example:
Router-N(configure)#
show vlan-area-mapping
User level: user, privileged, supervisor
Use the show vlan-area-mapping command to display all vlan-area
mappings.
The syntax for this command is:
show vlan-area-mapping [<vlanID>]
vlanID
Example:
Router-N>
332
An integer from 1 to 4094.
Map to the client area.
Map to the server area.
set vlan-area 1 servers
The vlan identification number, an integer from 1 to 4094.
show vlan-area-mapping 1
Avaya P330 Reference Guide