Show Security Mode; Show Self-Loop-Discovery - Avaya P330 Reference Manual

Use the show secure mac port command to display the secure MAC address
defined for a secured port.
The syntax for this command is:
show secure mac port [<mod-num>/<port-num>
mod-num
port-num
Example:
P330-N# show secure mac port 1/7
Port
------
1/7

show security mode

User level: user, privileged, supervisor
Use the show security mode command to display the status of the MAC
security feature.
Layer 2 commands are only available if you open a switch session with the
Master switch.
The syntax for this command is:
show security mode
Example:
P330-N# show security mode
Security mode enabled

show self-loop-discovery

User level: user, privileged, supervisor
This command is not available on P330-ML switches, hence a session should be
opened to the relevant P330 switch to execute this command.
Use the show self-loop-discovery command to display a switch's IBM token
ring cable discovery status.
Avaya P330 Reference Guide
Module where the secured port is located
Secured port number
Secure-Src-Addrs
-----------------
00-40-0d-9b-9d-00
00-40-0d-98-61-2e
00-40-0d-8a-a3-23
Chapter 2 Avaya P330 Layer 2 CLI Commands
]
147