Chapter 4
Load Balancing CLI Commands
Real SLB Server Commands
To configure a real server to be used by the Server Load Balancing (SLB)
application:
1
Use the real-slb-server command to enter a real SLB server context.
2
Use any of the remaining real-slb-server commands as required.
real-slb-server
User level: privileged, supervisor
You can also configure this command in user mode.
Use the real-slb-server command to create and/or enter a real SLB server
context. Use the no form of this command to delete a real server from using SLB.
The syntax for this command is:
real-slb-server <server-ip>
server-ip
Example:
Router-N(configure)# real-slb-server 10.1.1.2
real-slb-server admin-status
User level: privileged, supervisor
Use the admin-status command to set the administrative status to enable or
disable.
The syntax for this command is:
admin-status <enable | disable>
enable
disable
Example:
Router-N(configure)# admin-status enable
284
The IP address of the real server.
Set admin status to enable.
Set admin status to disable.
Avaya P330 Reference Guide