General Commands; Arp; Arp Timeout - Avaya P330 Reference Manual

Chapter 3 Avaya P330 Layer 3 CLI Commands

General Commands

arp

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the arp command to add a permanent entry to the Address Resolution Protocol
(ARP) cache.
Use the no arp command to remove an entry, either static entry or dynamically
learned.
The syntax for this command is:
[no] arp <ip-address> <mac-address>
ip-address
mac-address
Example:
To add a permanent entry for station 192.168.7.8 to the ARP cache:
Router-N(configure)# arp 192.168.7.8 00:40:0d:8c:2a:01
Example:
To remove an entry to the ARP cache for the station 192.168.13.76:
Router-N(configure)# no arp 192.168.13.76

arp timeout

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the arp timeout command to set the amount of time that an entry remains in
the ARP cache.
Use the no arp timeout command to restore the default value, 14,400.
164
IP address, in dotted decimal format, of the station
MAC address of the local data link
Avaya P330 Reference Guide