Chapter 3
Avaya P330 Layer 3 CLI Commands
Example:
Router-N(configure)# rmon2 matrix
Done!
rmon2 protocol-dist
User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
This command applies to the P333R only.
Use the rmon2 protocol-dist to enable the RMON2 Protocol Distribution
application.
Use the no rmon2 protocol-dist command to disable the application.
The syntax for this command is:
[no] rmon2 protocol-dist
Example:
Router-N(configure)# rmon2 protocol-dist
Done!
rmon2 subnets
User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
This command applies to the P333R only.
Use the rmon2 subnets command to enable the RMON2 subnets application.
Use the no rmon2 subnets command to disable the application.
The syntax for this command is:
[no] rmon2 subnets
192
Avaya P330 Reference Guide