Set Port Spantree Cost; Set Port Spantree Disable - Avaya P330 Reference Manual

<module/port>
Example:
P330-N# port self-loop-discovery Admin_Status enable 1/2
Self-Loop-Discovery enabled on port 1/2.

set port spantree cost

User level: privileged, supervisor.
Use the set port spantree cost command to set the cost of a port. This value
defines which port will be allowed to forward traffic if two ports with different costs
cause a loop.
The syntax for this command is:
set port spantree cost [module/port] [auto|value]
module/port
auto
value
Example:
P330-N>set port spantree cost 4/2 4096
port 4/2 spantree cost is 4096

set port spantree disable

User level: privileged, supervisor.
Use the set port spantree disable command to disable the spanning tree
mode for specific switch ports.
The syntax for this command is:
set port spantree disable [module/port]
Module
Port
Avaya P330 Reference Guide
Chapter 2
Module number/port number.
Spantree cost is calculated according to the standard
Number representing the cost. The cost level can be set
from 1 to 65535 / 200000000 in STP / RSTP, respectively.
A lower cost (lower value) specifies precedence of a port
to forward traffic.
Module number
Port number
Avaya P330 Layer 2 CLI Commands
75