virtual-fw-service hash-key
User level: privileged, supervisor
Use the hash-key command to set the hash table's key for the virtual firewall
service. Use the no form of this command to set the hash table's key of the virtual
firewall service to the default (src-dst).
The syntax for this command is:
[no] hash-key <src | dst | src-dst>
src
dst
src-dst
Example:
Router-N(configure)#
virtual-fw-service hc
User level: privileged, supervisor
Use the hc command to set a health check method for the virtual fw service. Use
the no form of this command to set the health check method for the virtual firewall
service to the default (auto).
The syntax for this command is:
[no] hc <auto | ping> [<specific-id>]
auto
ping
specific-id
Example:
Router-N(configure)#
Avaya P330 Reference Guide
The hash key is based on the source IP address.
The hash key is based on the destination IP address.
The hash key is based on the source and destination IP
addresses.
hash-key src
The default, which is the ping health check method.
Each server is periodically pinged and checked if an answer
was received.
The identification number of the health check.
hc ping 1
Chapter 4
Load Balancing CLI Commands
315