Table of Contents
Advertisement
Chapter 5
CLI – Layer 2
set port auto-negotiation-flowcontrol-advertisement
The set port auto-negotiation-flowcontrol-advertisement command
sets the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
The syntax for this command is:
set port auto-negotiation-flowcontrol-advertisement <mod_num>/
<port_num> {no-flowcontrol|asym-tx-only|sym-only|sym-and-asym-rx}
no-flowcontrol
asym-tx-only
sym-only
sym-and-asym-rx
Output Example:
P330-N#
1/5 asym-tx-only
P330-N# Port 1/5 pause capabilities was set
set trunk
Use the set trunk command to configure the tagging mode of a post.
set trunk [module/port] [value]
module/port
value
Output Example:
P330-1(super)# set trunk 2/20 dot1q
Dot1Q VLAN tagging set on port 2/20.
110
The port will advertise no pause capabilities.
The port will advertise asymmetric Tx pause capabilities only.
The port will advertise symmetric pause capabilities only.
The port will advertise both symmetric and asymmetric Rx
pause capabilities.
set port auto-negotiation-flowcontrol-advertisement
module/port number
off/dot1q
Avaya P333T-PWR User's Guide
Advertisement
Table of Contents
