Set Vlan; Set Port Flowcontrol - Avaya P334T-ML User Manual

The syntax for this command is:
set inband vlan <value>
value
Output Example:
P330-N# set inband vlan 1
Management VLAN number set to 1

set vlan

Use the set vlan command to create VLANs.
The syntax for this command is:
set vlan <vlan-id> [name <vlan-name>]
vlan-id
vlan-name
Output Example:
P330-N# set vlan 3 name v3
VLAN ID 3 is named v3.
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".

set port flowcontrol

Use the set port flowcontrol command to set the send/receive mode for
flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each
direction (send or receive) can be configured separately only for Gigabit Ethernet
ports. Proprietary flow control cannot be configured on Gigabit ports. The set
flowcontrol command cannot be used on Gigabit ports for which
autonegotiation is enabled.
The syntax for this command is:
set flowcontrol [direction] [module/port] [value]
where the parameters of direction are receive|send|all, and the parameters
of value are on|off|proprietary.
Avaya P334T-ML User's Guidee
A VLAN number between 1 and 3071.
vlan number
vlan name
Chapter 6 CLI – Layer 2
123