Virtual Server Commands
To configure a virtual server:
1
Use the virtual-server command to create/enter a virtual server context.
2
For a new virtual server, use the id command to set the identification number
for the virtual server (see virtual-server id on page 322).
3
Use any of the remaining virtual-server commands as required.
show virtual-server
User level: user, privileged, supervisor
Use the show virtual-server command to display all virtual servers.
The syntax for this command is:
show virtual-server [<server name>]
server name
Example:
Router-N>
show virtual-server details
User level: user, privileged, supervisor
Use the show virtual-server details command to display the full details
of all virtual servers.
The syntax for this command is:
show virtual-server details [<server name>]
server name
Example:
Router-N>
Avaya P330 Reference Guide
The name of the virtual server, a string up to 80 characters.
show virtual-server
The name of the virtual server, a string up to 80 characters.
show virtual-server details
Chapter 4
Load Balancing CLI Commands
321