Set Port Channel - Avaya P330 Reference Manual

asym-tx-only
sym-only
sym-and-asym-rx
Example:
P330-N# set port auto-negotiation-flowcontrol-
advertisement 1/5 asym-tx-only
Port 1/5 pause capabilities was set

set port channel

User level: privileged, supervisor.
Use the set port channel command to enable or disable a Link Aggregation
Group (LAG) interface on the switch. LAG creation requires a LAG name to be
specified. There is no default name.
You can also add or remove a port from an existing LAG. When adding or removing
a port to an existing LAG, type the same LAG-name. All ports in the LAG are
configured with the parameters of the first port that is added to the LAG. These
parameters include port administrative status, speed, duplex, autonegociation
mode, VLAN ID, tagging mode, binding mode, and priority level.
The ports added to a LAG must belong to the same LAG group - refer to the "LAG"
marking on device's front panel.
When adding a port to an existing LAG, type the same LAG name, otherwise
you will create a new LAG.
The syntax for this command is:
set port channel [<port_list>] [<value>] [<name>]
port_list
value
name
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".
Avaya P330 Reference Guide
Chapter 2
The port will advertise asymmetric Tx pause capabilities only.
The port will advertise symmetric pause capabilities only.
The port will advertise both symmetric and asymmetric Rx
pause capabilities.
A list of ports to be aggregated in the format module/port
on or off – enables or disables the channel for the specified
module ports
Channel name
Avaya P330 Layer 2 CLI Commands
59