Set Port Flowcontrol Command - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI
Example:
To set port 2 on module 1 to full duplex:
P130-1# set port duplex 1/2 full
Port 1/2 set to full-duplex.
P130-1#

Set port flowcontrol Command

Use the set port flowcontrol command to set the send/receive flow-control
frames (whether proprietary or IEEE 802.3x) for a full duplex module port. Each
direction can be configured separately.
This command is supported on Fast and Gigabit Ethernet switching ports.
The syntax for this command is:
set port flowcontrol {receive | send | all}<mod_num/
port_num>{off | on | prop}
receive
send
all
mod_num
port_num
off
on
prop
74
Indicates whether the port can receive administrative status
from a remote device. Available only for Gigabit Ethernet
modules with negotiation set to off.
Indicate whether the local port can send administrative status
to a remote device. Available only for Gigabit Ethernet
modules with negotiation set to off.
Send and receive (symmetric flow control).
Module number
Number of the port on the module
Used with receive to turn off an attached device's ability to
send flow-control packets to a local port. Used with send to
turn off the local port's ability to send administrative status to a
remote device.
Used with receive to require that a local port receive
administrative status from a remote device. Used with send,
the local port sends administrative status to a remote device.
Proprietary flow control.
Avaya P130 User's Guide