Copy Tftp Startup-Config; Copy Tftp Sw_Image - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

copy tftp startup-config

User level: privileged, supervisor.
This command applies to the P334T-ML only when it is in "Layer2"
device mode.
Use the copy tftp startup-config command to download a policy
configuration from the saved TFTP file to the Startup Configuration file in the
NVRAM.
The syntax for this command is:
copy tftp startup-config <filename> <ip>
filename
ip
Example (for Windows):
Router-N (super) # copy tftp startup-config
c:\p330\startup.cfg 149.49.100.41
Example: (for Unix):
Router-N (super) # copy tftp startup-config /folder/
startup.cfg 149.49.100.41

copy tftp SW_image

Use the copy tftp SW_image command to download a new firmware software
version into bank B while either keeping the old version in bank A, or downloading
the Embedded Web manager software into bank A.
The syntax for this command is:
copy tftp SW_image <sw_image_file> EW_archive <EmWeb_file>
<IP_addr> <mod_num>
sw_image_file
EmWeb_file
IP_addr
mod_num
20
Destination file name in the tftp server (full path)
The ip address of the tftp server.
Firmware image file name (full path)
Embedded Web Manager image file name (full path)
- Optional, can be a dummy name
The ip address of the TFTP server
Target switch module number
Avaya P330 Reference Guide