The syntax for this command is:
set port dot1x re-authenticate <module/port>
module/
port
Example:
P330-1(super)# set port dot1x re-authenticate 1/2
port 1/2 is not in authenticating process
set port dot1x re-authentication
User level: supervisor
Use the set port dot1x re-authentication command to set the re-
authentication mode per port.
The syntax for this command is:
set port dot1x re-authentication <module/port> <mode>
module/
port
mode
Example:
P330-1(super)# set port dot1x re-authentication 1/2 enable
port 1/2 re-authenticate was set to enable
set port dot1x re-authperiod
User level: supervisor
Use the set port dot1x re-authperiod command to set the the idle time
between re-authentication attempts before the session is terminated.
The syntax for this command is:
set port dot1x re-authperiod <module/port> <seconds>
module/
port
seconds
Avaya P330 Reference Guide
Module and port number (or range of ports)
Module and port number (or range of ports)
enable | disable
Module and port number (or range of ports)
Number of seconds – 0 to 65535
Chapter 2
Avaya P330 Layer 2 CLI Commands
63