Chapter 2
Avaya P330 Layer 2 CLI Commands
show intermodule port redundancy
User level: user, privileged, supervisor
Use the show intermodule redundancy command to display the intermodule
rport edundancy entry defined for the stack.
The syntax for this command is:
show intermodule port redundancy
Example:
P330-N>show intermodule port redundancy
Primary-Port
Primary-Port status
Secondary-Port
Secondary-Port status
show internal buffering
Use the show internal buffering command to display the size options
(Maximum, Minimum, or Medium) of the Receive (Rx) buffer allocated to each port
of the specified switch.
Internal buffering for the P330-ML switches will always have the value Not
supported. This command is used to display the internal buffering status for
the other P330 switches in the stack
The syntax for this command is:
show internal buffering [<mod_num>]
mod_num
Example:
P330-N>show internal buffering 1
Module
------
1
110
Switch number. If you do not specify a number then
the internal buffering for all switches in the stack will
be displayed.
Internal Buffer
---------------
med
: 1/1
: Disable
: 1/2
: Disable
Avaya P330 Reference Guide