Set Radius Authentication Server; Set Radius Authentication Udp-Port - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

set radius authentication server

User level: supervisor
Sets the IP address (and shared secret) of the primary or secondary RADIUS
Authentication server.
The syntax for this command is:
set radius authentication server <ip-addr> {primary |
secondary}
ip-addr
primary
secondary
Example:
P330-1(super)# set radius authentication server
192.40.12.36 primary

set radius authentication udp-port

User level: supervisor
Use the set radius authentication udp-port command to set the RFC
2138 approved UDP port number.
Normally, the UDP port number should be set to its default value of 1812. Some
early implementations of the RADIUS server used port number 1645.
The syntax for this command is:
set radius authentication udp-port <number>
Example:
P330-1(super)# set radius authentication udp-port 300
86
IP address of the RADIUS authentication server
default - Primary authentication server
Secondary authentication server
Avaya P330 Reference Guide