Example:
To turn the ICMP error messages on:
Router-N(configure)# ip icmp-errors
Done!
ip max-arp-entries
User level: privileged, supervisor.
•
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip max-arp-entries command to set the maximum number of ARP
cache entries allowed in the ARP cache.
Use the no ip max-arp-entries command to restore the default value of 4096.
This command takes effect only after start-up.
The syntax for this command is:
[no] ip max-arp-entries <value>
value
Example:
To set the maximum number of ARP cache entries to 8000:
Router-N(configure)# ip max-arp-entries 8000
To restore the maximum number of ARP cache entries to its default:
Router-N(configure)# no ip max-arp-entries
Avaya P330 Reference Guide
The space available for the IP address table. When you decrease the
number of entries, it may cause the table to be relearned more
frequently. If you do not enter a value, then the current ARP Cache
size is shown.
Chapter 3
Avaya P330 Layer 3 CLI Commands
183