Set Leaky-Vlan; Set License - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

set leaky-vlan

User level: privileged, supervisor.
This command is not available on P330-ML switches: P330-ML modules do not
support the leaky-vlan feature.
Use the set leaky-vlan command to define the P330 stack's leaky VLAN mode.
In this mode, VLAN test is done only on broadcast/multicast/unknown frames,
and not on unicast frames.
The syntax for this command is:
set leaky-vlan <value>
value
Example:
P330-N# set leaky-vlan enable
Leaky VLAN mode enabled

set license

User level: privileged, supervisor.
Use the set license command to activate the SMON and Routing capabilities
of the Avaya P330 stack. An Avaya P330 stack can include several Avaya P330
switches. One SMON license is required per Avaya P330 stack; a routing license is
required for each P330-ML switch in the stack.
For a full description of the SMON or Routing License and the installation
procedure please refer to the Installation Guide provided with the SMON/Routing
License.
The syntax for this command is:
set license [module] [license] [feature name]
module
license
feature name
Example:
P330-N# set license 1 021 1ad bad ca5 8d2 ccd smon
56
enable/disable
Switch number
License number
Name of the feature, either smon or routing
Avaya P330 Reference Guide