virtual-ar-service hash-key
User level: privileged, supervisor
Use the hash-key command to set the hash table's key for the virtual AR service.
Use the no form of this command to set the hash table's key to the default (dest).
The syntax for this command is:
[no] hash-key <src | dst | src-dst>
src
dst
src-dst
Example:
Router-N(configure)# hash-key src
virtual-ar-service hc
User level: privileged, supervisor
Use the hc command to set a health check method for the virtual AR service. Use
the no form of this command to set the health check method for the virtual AR
service to the default (auto).
The syntax for this command is:
[no] hc <auto | ping | tcp-connect | http | script>
[<specific-id>]
auto
ping
tcp-connect
http
script
specific-id
Avaya P330 Reference Guide
The hash key is based on the source IP address.
The hash key is based on the destination IP address.
The hash key is based on the source and destination IP
addresses.
The default, which is the ping health check method.
Each server is periodically pinged and checked if an answer
was received.
A TCP connection is periodically opened to every server,
checking for successful completion of the connection.
Enables verifying HTTP server functioning by comparing the
response from the server with a user-configurable response.
Verifies the functioning of the server by running a script on
the server.
The identification number of the health check.
Chapter 4
Load Balancing CLI Commands
309