Set Ppp Baud-Rate; Set Ppp Chap-Secret; Set Ppp Incoming Timeout - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

set ppp baud-rate

User level: privileged, supervisor.
Defines the baud rate used in PPP sessions.
The peer baud rate must be set at the same value as the host.
The syntax for this command is:
set ppp baud-rate <9600|19200|38400>
Example:
P330-N# set ppp baud-rate 38400
ppp baud rate was set to 38400

set ppp chap-secret

User level: supervisor
Use the set ppp chap-secret command to configure the "shared secret" used
in PPP sessions with CHAP authentication. The chap-secret is not transferable via
the configuration upload/download mechanism.
The syntax for this command is:
set ppp chap-secret <chap-secret>
chap-secret
Example:
P330-1(super)# set ppp chap secret hush
PPP shared secret for CHAP authentication is set

set ppp incoming timeout

User level: privileged, supervisor.
Use the set ppp incoming timeout command to set the number of minutes
until the system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
set ppp incoming timeout <time>
time
82
The shared secret, 4 to 32 characters.
The timeout in minutes
Avaya P330 Reference Guide