Ip Simulate - Avaya P330 Reference Manual

The syntax for this command is:
ip access-list-owner <policy-list-number> <owner>
<policy-list-number>
<owner>
Example:
Router-N# ip access-list-owner 101 admin
Done!

ip simulate

User level: privileged, supervisor.
This command applies to the P334T-ML only when it is in device mode
"Layer2".
Use the ip simulate command to check the policy for a simulated packet. The
command contains the addressed list number, and the packet parameters.
The syntax for this command is:
ip simulate <policy-list-number> [<priority>] [<dscp-
value>]<source> <destination> [<protocol> [<source port>
<destination port> [<established>]]]
policy-list-number
priority
dscp-value
source
destination
protocol
source port
destination port
established
Avaya P330 Reference Guide
Chapter 2 Avaya P330 Layer 2 CLI Commands
integer (100...149)
list owner
integer (100...149, 0-default list)
fwd0 | fwd1 | ... | fwd7
dscp0 | dscp1 | ... | dscp63
source ip address
destination ip address
ip | tcp | udp | integer (1...255)
integer (1...65535)
integer (1...65535)
value of TCP established bit
31