Chapter 3
Avaya P330 Layer 3 CLI Commands
set policy type
User level: privileged, supervisor.
This command is available on the P334T-ML switch in device mode "Router"
only.
Use the set policy type command to set whether the P334T-ML module
enforces the active policy-list on all packets or only on routed packets (for modules
in 'device-mode router').
The syntax for this command is:
set policy type
value
Example:
Router-N# set policy type all
set qos dscp-cos-map
User level: privileged, supervisor.
This command applies to the P333R only.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set qos dscp-cos-map command to configure the DSCP table.
The syntax for this command is:
set qos dscp-cos-map <dscp1>[-<dscp2>] <operation>
[<precedence>]
dscp1
dscp
operation
precedence
198
<value> all | router
all - apply policy to all packets entering the
P334T-ML through Fast Ethernet ports
router - apply policy on routed packets only
dscp range min (0-63)
dscp range max (0-63)
fwd0-7 | no-change
mandatory | optional
Avaya P330 Reference Guide