Chapter 3
Avaya P330 Layer 3 CLI Commands
The syntax for this command is:
ip unicast cache aging timeout <time>
Example:
Router-N(configure)# ip unicast cache aging timeout 10
Done!
ip unicast cache high-limit
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
This command applies to the P333R only.
Use the ip unicast cache high-limit command to configure the maximum
number of routing cache entries.
Use the no ip unicast cache high-limit command to reset the parameter
to its default value.
The syntax for this command is:
[no] ip unicast cache high-limit <limit>
limit
Example:
Router-N(configure)# ip unicast cache high-limit 1200
Done!
ip unicast cache update-timeout
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
This command applies to the P333R only.
Use the ip unicast cache update-timeout command to configure the
timeout (in seconds) used to remove inactive cache entries.
188
Integer; sets the maximum number of routing
cache entries. Default value - 16384 Value range -
800 to 16384
Avaya P330 Reference Guide