Ip Access-List-Dscp Operation; Ip Access-List-Dscp Trust - Avaya P330 Reference Manual

ip access-list-dscp operation

User level: privileged, supervisor.
Use the ip access-list-dscp operation command to set a DSCP to CoS
mapping.
On the P334T-ML, the system performs the mapping for only those frames than
match an ACL rule with a "permit" action.
The syntax for this command is:
ip access-list-dscp operation <policy-list-number> <dscp>
<action>
policy-
list-
number
dscp
action
Example:
Router-N(configure)# ip access-list-dscp operation 101 0-63
permit
Router-N(configure)# ip access-list-dscp operation 101 62
fwd5

ip access-list-dscp trust

User level: privileged, supervisor.
Use the ip access-list-dscp trust command to decide which original
frame fields influence the selection of packet priority.
This command does not apply to the P333R.
The syntax for this command is:
Avaya P330 Reference Guide
A valid id number for a policy list currently defined for the module
(100 - 149)
Range of dscp. For example:
<dscp-range> : [0 - 63] | <low-dscp>-<high-dscp> <low-dscp>-<low-
dscp>: apply the map to all packets with DSCP from <low-dscp> to
<high-dscp>.
<action> = permit | deny | deny-and-notify | fwd0 | fwd1 - fwd7
• permit: do nothing, let the packet pass:
• deny: drop the packet
• deny-and-notify: drop the packet and send an SNMP trap
• fwd0, fwd1fwd7: Set the frame COS field to 0,7
Chapter 3 Avaya P330 Layer 3 CLI Commands
179