Set Vlan; Set Port Flowcontrol - Avaya P332MF User Manual

Avaya stackable switch user's guide
Hide thumbs Also See for P332MF:
Table of Contents

Advertisement

Chapter 6
CLI – Layer 2
The syntax for this command is:
set inband vlan <value>
value
Output Example:
P330-N# set inband vlan 1
Management VLAN number set to 1

set vlan

Use the set vlan command to create VLANs.
The syntax for this command is:
set vlan <vlan-id> [name <vlan-name>]
vlan-id
vlan-name
Output Example:
P330-N# set vlan 3 name v3
VLAN ID 3 is named v3.
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".

set port flowcontrol

Use the set port flowcontrol command to set the send/receive mode for
flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each
direction (send or receive) can be configured separately only for Gigabit Ethernet
ports. Proprietary flow control cannot be configured on Gigabit ports. The set
flowcontrol command cannot be used on Gigabit ports for which
autonegotiation is enabled.
The syntax for this command is:
set flowcontrol [direction] [module/port] [value]
where the parameters of direction are receive|send|all, and the parameters
of value are on|off|proprietary.
112
A VLAN number between 1 and 3071.
vlan number
vlan name
Avaya P332MF User's Guide

Advertisement

Table of Contents
loading

Table of Contents