Erase Startup-Config; Event Clear; Event Log - Avaya P330 Reference Manual

Chapter 3 Avaya P330 Layer 3 CLI Commands
Example:
Router-N> copy tftp startup-config c:\P330\router1.cfg
192.168.49.10

erase startup-config

Use the erase startup-config command to clear the startup configuration.
The syntax for this command is:
erase startup-config
Example:
Router-N(configure)# erase startup-config

event clear

User level: user, privileged, supervisor
This command applies to the P333R and P333R-LB only.
Use the event clear command to clear the event log.
The syntax for this command is:
clear [SILENT]
SILENT
Example:
Router-N(configure)# event clear

event log

Use the event log command to display a list of the event messages.
The event messages shown are encrypted and are reserved for Avaya use only.
The syntax for this command is:
event log [<num>]
num
170
Do not write "event log was cleared" message to the
event log
Number of event messages to display (max=30)
Avaya P330 Reference Guide