Chapter 4
Load Balancing CLI Commands
virtual-server virtual-slb-service application
User level: privileged, supervisor
Use the application command to set an application for the virtual SLB service.
Use the no form of this command to set the application for the virtual SLB service
to the default (IP-all ports).
The syntax for this command is:
application <tcp | udp | ip <protocol>> [<min-v-port> [<max-v-
port>]]
protocol
min-v-port
max-v-port
Example:
Router-N(configure)#
virtual-server virtual-slb-service hash-key
User level: privileged, supervisor
Use the hash-key command to set the hash table's key for the virtual SLB service.
Use the no form of this command to set the hash key, for the virtual SLB service, to
the default (src).
The syntax for this command is:
[no] hash-key <src | dst | src-dst>
src
dst
src-dst
Example:
Router-N(configure)#
326
The protocol of the virtual SLB service: UDP, TCP, IP, or
protocol number from 0 to 255.
Minimum port number, from 0.
Maximum port number, up to 65535.
application udp 12 15
The hash key is based on the source IP address.
The hash key is based on the destination IP address.
The hash key is based on the source and destination IP addresses.
hash-key src
Avaya P330 Reference Guide