Set Timezone; Set Trunk - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

set timezone

User level: privileged, supervisor.
Use the set timezone command to assign a timezone name and sets the time
difference of the device relative to the Coordinated Universal Time (UTC / GMT).
The minutes parameter can only be set to 30.
The syntax for this command is:
set timezone <zone-name> [-]<hours>[:30]
zone-name
hours
Example:
P330-N# set timezone EST -5
Timezone set to "EST", offset from UTC is -5 hours.

set trunk

User level: privileged, supervisor.
Use the set trunk command to configure the VLAN tagging mode of a port.
set trunk <module/port> {off|dot1q}
module
port
off
dot1q
Example:
P330-1#
Dot1Q VLAN tagging set on port 3/3.
98
Three-character name of time zone, for example, EST, GMT
The difference between the time zone and GMT
Number of the switch.
Number of the port on the switch.
You can also specify a range of ports separated by a dash,
for example, 4/5-13 for ports 5 to 13 on switch 4.
Forces the port to become a non-tagging port.
Specifies an IEEE 802.1Q tagging on a Fast Ethernet or
Gigabit Ethernet port.
set trunk 3/3 dot1q
Avaya P330 Reference Guide