Router Rip Context; Network; Redistribute - Avaya P330 Reference Manual

Router RIP Context

You can only access these commands in the "Router-RIP" context.
Type router rip at the command prompt to enter the "Router-RIP" context if
necessary.

network

User level: privileged, supervisor.
Use the network command to specify a list of networks on which the RIP is
running.
Use the no network command to remove an entry.
The syntax for this command is:
[no] network <ip-address> [<wildcard-mask>]
ip addr
wildcard-mask
Example:
To specify that RIP will be used on all interfaces connected to the network
192.168.37.0:
Router-N(configure router:rip)# network 192.168.37.0
Done!

redistribute

User level: privileged, supervisor.
Use the redistribute command to redistribute routing information from other
protocols into RIP.
Use the no redistribute command to disable redistribution by RIP.
The default is disabled.
The syntax for this command is:
[no] redistribute <protocol>
protocol
Avaya P330 Reference Guide
Chapter 3
The IP address of the network of directly connected networks
Wildcard mask address. Exists for compatibility with P550.
Either Static or OSPF
Avaya P330 Layer 3 CLI Commands
253