Clear Arp-Cache - Avaya P330 Reference Manual

The syntax for this command is:
[no] arp timeout <seconds>
seconds
Example:
To set the arp timeout to one hour:
Router-N(configure)# arp timeout 3600
To restore the default arp timeout:
Router-N(configure)# no arp timeout

clear arp-cache

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the clear arp-cache command to delete dynamic entries from the ARP
cache and the IP route cache.
The syntax for this command is:
clear arp cache[<vlan>|<ip addr>[<mask>]]
vlan
ip addr
mask
Example:
Router-N(configure)# clear arp-cache
Flushing all arp entries
Flushed 100 ARP entries
Done!
Avaya P330 Reference Guide
Chapter 3
The amount of time, in seconds, that an entry remains
in the arp cache.
VLAN string (up to 16 characters)
IP address
IP mask
Avaya P330 Layer 3 CLI Commands
165