Chapter 4
Load Balancing CLI Commands
virtual-fw-service hc-ip
User level: privileged, supervisor
Use the hc-ip command to set the health check IP addresses for the virtual
firewall service.
The syntax for this command is:
hc-ip <my-ip> <partner-ip>
my-ip
partner-ip
Example:
Router-N(configure)#
virtual-fw-service id
User level: privileged, supervisor
Use the id command to set the identification number and type for the virtual
firewall service.
The syntax for this command is:
id <id> [bridging-fw]
id
bridging-fw
Example:
Router-N(configure)#
316
My IP address.
Partner's IP address.
hc-ip 10.10.1.2 10.20.2.3
Identification number for the virtual firewall service, an
integer from 1 to 1024.
Add this parameter to configure a bridging firewall type. If
this parameter is not included in the command, a routing
firewall type is configured.
id 1 bridging-fw
Avaya P330 Reference Guide