Example:
P330-N# set port point-to-point admin status 1/1 force-true
port 1/1 point to point admin status is set to force-true
set port powerline
User level: privileged, supervisor.
This command is available on P333T-PWR switches only
Use the set port powerinline command to enable or disable the load detection
process and power delivery for the port.
The syntax for this command is:
set port powerinline <module_number/port_number> {[enable] |
disable}
module_
number
port_nu
mber
Example:
P330-N# set port powerinline 3/1-3 enable
Load detection process on ports 3/1-3 is enabled
set port powerline priority
User level: privileged, supervisor.
This command is available on P333T-PWR switches only
Use the set port power inline priority command to configure the priority
level of powering the port. Possible values are Critical, High, and Low. At power on
all ports are set to Low Priority.
Within each group, the lowest port number has a highest priority, i.e. within the
ports 1 to 8, port 1 has the highest priority although its priority is lower than port 9
which belongs to High priority group.
Avaya P330 Reference Guide
Number of the module hosting the port for which load detection is to
be enabled/disabled.
Number of the port for which load detection should be enabled/
disabled.
enable - enables load detection process for port
disable - disables load detection process for port
Chapter 2
Avaya P330 Layer 2 CLI Commands
71