Virtual-Ar-Service Persistency; Virtual-Ar-Service Persistency Time; Virtual-Ar-Service Persistency Wildcard - Avaya P330 Reference Manual

virtual-ar-service persistency

User level: privileged, supervisor
Use the persistency command to enable persistency for the virtual AR service.
Use the no form of this command to set the persistency for the virtual AR service
to the default (disable).
The syntax for this command is:
[no] persistency
Example:
Router-N(configure)# persistency

virtual-ar-service persistency time

User level: privileged, supervisor
Use the persistency time command to set the persistency time for the virtual
AR service. Use the no form of this command to set the persistency time for the
virtual AR service to the default (3600 seconds).
The syntax for this command is:
[no] persistency time <time>
time
Example:
Router-N(configure)# persistency time 3000

virtual-ar-service persistency wildcard

User level: privileged, supervisor
Use the persistency wildcard command to set the persistency wildcard for
the virtual AR service. The persistency wildcard command extends the
range of client IP addresses to those addresses which the persistency applies. Use
the no form of this command to set the persistency wildcard for the virtual AR
service to the default (0.0.0.0).
The syntax for this command is:
[no] persistency wildcard <wildcard>
wildcard
Avaya P330 Reference Guide
The time in seconds, an integer.
The client IP network wildcard.
Chapter 4 Load Balancing CLI Commands
311