Set Spantree Default-Path-Cost; Set Spantree Disable; Set Spantree Enable - Avaya P330 Reference Manual

set spantree default-path-cost

User level: privileged, supervisor.
Use the set spantree default-path-cost command to set the version of the
spanning tree default path costs that are to be used by this bridge.
The syntax for this command is:
set spantree default-path-cost <path-cost>
path-cost
Example:
P330-N# set spantree default-path-cost rapid-spanning-tree
Spanning tree default path costs is set to rapid spanning
tree.

set spantree disable

User level: privileged, supervisor.
Use the set spantree disable command to disable the spanning-tree
algorithm for the switch.
When you disable STP, blocking ports are disabled in order to prevent loops in
the network. As a result, you need to wait 30 seconds before disabling STP if
you reset the switch, enable STP, or insert a new station.
The syntax for this command is:
set spantree disable
Example:
P330-N# set spantree disable
bridge spanning tree disabled.

set spantree enable

User level: privileged, supervisor.
Use the set spantree enable command to enable the spanning-tree algorithm
for the switch.
When you disable STP, blocking ports are disabled in order to prevent loops in
the network. As a result, you need to wait 30 seconds before disabling STP if
you reset the switch, enable STP, or insert a new station.
Avaya P330 Reference Guide
Chapter 2
common-spanning-tree - compatible with ieee802.1D standard
rapid-spanning-tree - compatible with ieee802.1W standard
Avaya P330 Layer 2 CLI Commands
91