Disconnect Ssh; Erase Startup-Config - Avaya P330-ML-ML Reference Manual

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
included in the configuration file. Therefore, it is important to reinitialize the
NVRAM to the factory default settings before downloading configuration files
to the switch. To reinitialize the NVRAM, run the nvram initialize
command.
The syntax for this command is:
copy tftp startup-config <filename> <ip>
filename
ip
Example:
Router-N> copy tftp startup-config c:\P330-ML\router1.cfg
192.168.49.10

disconnect ssh

User level: supervisor
Use the disconnect ssh command to disconnect an SSH session.
The syntax for this command is:
disconnect ssh <session-id>
session-id
Example:
P330-ML-2# disconnect ssh 0x508622f0
You are about to close this session - do you want to
continue (Y/N)? y
Closing session 0x508622f0

erase startup-config

Use the erase startup-config command to clear the startup configuration.
The syntax for this command is:
erase startup-config
222
file name (full path)
The ip address of the host
The SSH session ID. Use the show ssh command to
learn an SSH session ID.
Avaya P330-ML Reference Guide