Chapter 6
CLI – Layer 2
alarm 1026 was created successfully
rmon event
Use the rmon event command to create an RMON event entry.
The syntax for this command is:
rmon event <Event Number> <type> description <description>
owner <owner>
event number
type
description
owner
Output Example:
P330-N#
monitoring amir's computer" owner amir
event 1054 was created successfully
copy stack-config tftp
Use the copy stack-config tftp command to upload the stack-level
parameters from the current NVRAM running configuration into a file via TFTP.
Note: Create the file into which you wish to upload the stack-level parameters prior
to executing this command.
The syntax for this command is:
copy stack-config tftp <filename> <ip>
filename
ip
Output Example:
P330-N# copy stack-config tftp c:\conf.cfg 192.168.49.10
Beginning upload operation ...
128
This is the event index number of this entry.
The type of the event. The possible parameters are:
trap, log, logAndTrap, none.
A user description of this event
Owner name string
rmon event 1054 logAndTrap description "event for
The file name (full path)
The IP address of the TFTP server
Avaya P333T User's Guide