Brocade Communications Systems WFT-2D User Manual page 334

7
Status widgets
•
•
•
•
•
•
•
•
•
Customizing the Bottlenecked Ports widget
You can customize the widget to display data for a specific fabric and duration:
•
•
Accessing additional data from the Bottlenecked Ports widget
Right-click a row in the widget to access the shortcut menu available for the associated device. For
more information about shortcut menus, refer to
282
Port — The port identifier, such as port name, number, address, WWN, user port number, or
zone alias.
Connected_Port_Link (where Connected_Port_Link is Connected Port, Initiator, or Target) —
Displays one of the following:
-
Connected Port — The ISL or IFL port on the connected device. Click to launch the switch
port properties dialog box.
-
Initiator — The initiator port on the connected device. Click to launch the device properties
dialog box.
-
Target — The target port on the connected device. Click to launch the device properties
dialog box.
Violation Count — The number of bottleneck violations for the port during the selected time
range. This is based on bottleneck configuration. Each trap or alert sent by the switch and the
Management application counts as one violation. For more information, refer to
detection" on page 1100.
-
Congestion — The number of bottleneck violations caused due to congestion for the port
during the selected time range.
-
Latency — The number of bottleneck violations caused due to latency for the port during
the selected time range.
NOTE
The Bottleneck violation for the AN -1010 event is shown in the Latency count. The Latency
count increases to 1 in all Bottlenecked Ports widgets.
Product — The product label, such as product name, IP address, node WWN, domain ID, or
zone alias.
Type — The port type.
Identifier — The port identifier, such as port name, number, address, WWN, user port number,
or zone alias.
Port Number — The port number.
State — Whether the port is online or offline.
Status — Whether the port is online or offline.
To display data for a specific fabric or group, refer to
page 275.
To display data for a specific duration, refer to
"Creating a customized network scope"
"Customizing the time scope"
"Application menus" on page 1411.
Brocade Network Advisor SAN User Manual
"Bottleneck
on
on page 278.
53-1003154-01