Table of Contents
Advertisement
IM_MANAGER3000+_TC02_REV00_04_21_EN
BACNET INTERFACE
3.
3.1
Components required
The components required to interface the system managed by the Manager30000+ electronic controller to the BACNET system are described below.
BACNET MS/TP board (for the RS485 network) or
BACNET/IP board (for the Ethernet network)
Board inside the Manager3000+ control panel if
requested by the customer
3.2
Installing the BACNET system serial interface board
Follow the points in paragraph 1 "Installing the serial board" to insert the MODBUS serial board into the controller.
3.3
Setting supervisor parameters
3.3.1
BACNET MS/TP
The communication with the BMS requires the setting of dedicated parameters through the Web interface or the touchscreen
(access the menu using the
key and select the "Device Configuration" page) as described below:
Figure 3.3: "Device settings" screen display
In the SUPERVISOR SETTINGS section set:
PROTOCOL
ADDRESS
MEHITS S.p.A. ● INTERFACE MANUAL
Figure 3.1: boards display
Figure 3.2: internal board display
Modbus Over IP/ Modbus RTU/ BACnet MSTP/ BACnet
Address to assign to MANAGER3000+ in the bacnet network
14
Version 02 - Translation of the original instructions
Advertisement
Table of Contents
