Committing The Configuration - Juniper T640 Quick Start Manual

T640 Core Router Quick Start

Committing the Configuration

44
Configure the IP address of a backup routing engine. The backup routing engine is
5.
used while the local router is booting and if the routing process fails to start. After the
routing process starts, the backup routing engine address is removed from the local
routing and forwarding tables.
[edit]
root# set system backup-router address
(Optional) Configure the static routes to remote subnets with access to the
6.
management port. Access to the management port is limited to the local subnet. To
access the management port from a remote subnet, you must add a static route to
that subnet within the routing table.
[edit]
root# set routing-options static route remote-subnet next-hop destination-IP retain
no-readvertise
Configure the telnet service at the
7.
[edit]
set system services telnet
For a chassis with two Routing Engines, commit the configuration changes to both Routing
Engines. When you issue the
between both Routing Engines and committed on both Routing Engines simultaneously.
For a chassis with only one Routing Engine, use the
command.
commit synchronize
Display the configuration to verify that it is correct.
1.
root# show
## Last changed: 2008-10-17 18:32:25 UTC
version 9.1R1.8;
groups {
re0 {
system {
host-name spice-re0;
}
interfaces {
fxp0 {
unit 0 {
family inet {
address 192.168.69.155/21;
}
}
}
}
}
re1 {
system {
host-name spice-re1;
}
interfaces {
fxp0 {
[edit system services]
command, the configuration is shared
commit synchronize
commit
Copyright © 2015, Juniper Networks, Inc.
hierarchy level.
command instead of the