Committing The Configuration - Juniper T4000 Quick Start Manual

T4000 Core Router Quick Start

Committing the Configuration

32
Configure the router's domain name.
3.
[edit]
root@# set system domain-name domain-name
Configure the IP address and prefix length for the router's management Ethernet
4.
interface.
NOTE: The RE-C1800 Routing Engine (
the interface or the
fxp0
the em0 interface for the RE-C1800 Routing Engine.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
Configure the IP address of a backup routing engine. The backup routing engine is
5.
used while the local router is booting and if the routing process fails to start. After the
routing process starts, the backup routing engine address is removed from the local
routing and forwarding tables.
[edit]
root# set system backup-router address
(Optional) Configure the static routes to remote subnets with access to the
6.
management port. Access to the management port is limited to the local subnet. To
access the management port from a remote subnet, you must add a static route to
that subnet within the routing table.
[edit]
root# set routing-options static route remote-subnet next-hop destination-IP retain
no-readvertise
Configure the telnet service at the
7.
[edit]
set system services telnet
For a chassis with two Routing Engines, commit the configuration changes to both Routing
Engines. When you issue the
between both Routing Engines and committed on both Routing Engines simultaneously.
For a chassis with only one Routing Engine, use the
command.
commit synchronize
Display the configuration to verify that it is correct.
1.
root# show
## Last changed: 2008-10-17 18:32:25 UTC
version 9.1R1.8;
groups {
re0 {
system {
host-name spice-re0;
}
RE-DUO-1800
and internal Ethernet interfaces. Use
fxp1 fxp2
[edit system services]
command, the configuration is shared
commit synchronize
commit
Copyright © 2012, Juniper Networks, Inc.
) does not support
hierarchy level.
command instead of the