Committing The Configuration - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

Committing the Configuration

144
(Optional) Configure the static routes to remote subnets with access to the
6.
management port. Access to the management port is limited to the local subnet. To
access the management port from a remote subnet, you must add a static route to
that subnet within the routing table.
[edit]
root# set routing-options static route remote-subnet next-hop destination-IP retain
no-readvertise
Configure the telnet service at the
7.
[edit]
set system services telnet
Display the configuration to verify that it is correct.
1.
[edit]
root@# show
system {
host-name host-name;
domain-name domain-name;
backup-router address;
root-authentication {
authentication-method (password | public-key);
}
name-server {
address;
}
}
interfaces {
em0 {
unit 0 {
family inet {
address address/prefix-length;
}
}
}
}
Commit the configuration to activate it on the router.
2.
[edit]
root@# commit
Optionally, configure additional properties by adding the necessary configuration
3.
statements. Then commit the changes to activate them on the router.
[edit]
root@host# commit
When you have finished configuring the router, exit configuration mode.
4.
[edit]
root@host# exit
root@host>
hierarchy level.
[edit system services]
Copyright © 2010, Juniper Networks, Inc.